Floors = pain

When we tore up that gross red carpet in the back bedroom we found old wide plank floors underneath. They appeared to be in great condition except for one small problem: they were covered in layers and layers of paint. The paint was likely very old (i.e. lead?) and two tone. The middle of the floor was gold in color and the outside was dark brown. I was VERY concerned about sanding: if the paint contained lead, sanding would make the lead airborne...which is the worst way to be exposed. I figured we already exposed ourselves to some pretty terrible toxins during demolition...no matter how careful we were. So we got some paint stripper...a biodegradable variety...and tried that. The layer of brown paint wiped off with a paper towel, but the stripper didn't even disturb the gold or approximately 30 layers underneath the gold.

So what to do?

When we lived in our Carriage House in Providence, the previous owners had painted the exposed beams. We had to scrape the beams to uncover the gorgeous wood underneath and Jon still had the scraper we used, so he tried it on the floors. Success.

However...exposing a few beams is one thing. Scraping an entire floor is a whole other nightmare. Jon actually sweat through his shorts. I've never seen that before. I understand sweating through a shirt...but shorts? And the whole time he was doing this he had to wear a respirator...which made it a doubly awful task. Try breathing heavily into a respirator...

So then we rented a commercial grade, EPA approved sander. Awesome, right? Well...remember that our house is over 100 years old. The floorboards aren't necessarily level. In fact most of them are bowed one way or the other. So putting a big belt sander on top, will only really work on part of the board. Ugh. But at least it helped a little.

All in all we estimate that the whole process took Jon about F-O-R-T-Y hours. I felt so bad. Sincerely awful.

In the process, we found a layer of old newspaper under the paint in one corner. Weird right? Why would they have put paint down and then painted on top? Who knows...but we did get to scrap up a few pieces that are even readable. Take a look: